CLI Guide

initialization of CAM, the chassis manager reads the NVRAM and allocates the
dynamic VCAP regions.
The following table describes the output fields of this show command:
Field Description
Chassis Vlan Cam
ACL
Details about the CAM blocks allocated for ACLs for various
VLAN operations at a system-wide, global level.
Stack Unit
<number>
Details about the CAM blocks allocated for ACLs for various
VLAN operations for a particular stack unit.
Current
Settings(in block
sizes)
Information about the number of FP blocks that are
currently in use or allocated.
VlanOpenFlow Number of FP blocks for VLAN open flow operations.
VlanIscsi Number of FP blocks for VLAN internet small computer
system interface (iSCSI) counters.
VlanHp Number of FP blocks for VLAN high performance processes.
VlanFcoe Number of FP blocks for VLAN Fiber Channel over Ethernet
(FCoE) operations.
VlanAclOpt Number of FP blocks for ACL VLAN optimzation feature.
Example
Dell# show cam-acl-vlan
-- Chassis Vlan Cam ACL --
Current Settings(in block sizes)
VlanOpenFlow : 0
VlanIscsi : 0
VlanAclOpt : 2
VlanHp : 1
VlanFcoe : 1
Dell#
cam-acl-vlan
Allocate the number of flow processor (FP) blocks or entries for VLAN services and processes.
Syntax
cam-acl-vlan { default | vlanopenflow <0-2> | vlaniscsi <0-2> |
vlanaclopt <0-2>
Parameters
default Reset the number of FP blocks to default. By default, 0
groups are allocated for the ACL in VCAP. ACL VLAN groups
or CAM optimization is not enabled by default, and you
need to allocate the slices for CAM optimization.
380
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)