CLI Guide

If you do not define a keyword (permit or deny) for the route map, the permit
action is the default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Use caution when you delete route maps because if you do not specify a sequence
number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)# route-map dempsey
Dell(config-route-map)#
Related
Commands
• show config — display the current configuration.
set as-path
To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
Syntax
set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number
| tag} command.
Access Control Lists (ACL)
303