CLI Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
• match interface — redistribute routes that match the next-hop interface.
• match ip address — redistribute routes that match an IP address.
• match ip next-hop — redistribute routes that match the next-hop IP address.
• match ip route-source — redistribute routes that match routes advertised by
other routers.
• match route-type — redistribute routes that match a route type.
• match tag — redistribute routes that match a specific tag.
match origin
To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.
Syntax
match origin {egp | igp | incomplete}
To disable matching filter, use the no match origin {igp | egp |
incomplete} command.
Parameters
egp Enter the keyword egp to match routes originating outside
the AS.
igp Enter the keyword igp to match routes originating within
the same AS.
incomplete Enter the keyword incomplete to match routes with
incomplete routing information.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
Access Control Lists (ACL)
299