CLI Guide

of 00:00:00:00:00:00 only allows entries that match
exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword count to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the
filter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the
monitored interface.
NOTE: For more information, see Flow-based
Monitoring in the “Port Monitoring” section of the Dell
Networking OS Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
Access Control Lists (ACL)
281