CLI Guide

Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications about entries allowed per ACL, refer to your line card
documentation.
Prior to 7.8.1.0, names are up to 16 characters long.
Example
Dell(conf)# mac-access-list access-list extended TestMATExt
Dell(config-ext-macl)# remark 5 IPv4
Dell(config-ext-macl)# seq 10 permit any any ev2 eq 800 count
bytes
Dell(config-ext-macl)# remark 15 ARP
Dell(config-ext-macl)# seq 20 permit any any ev2 eq 806 count
bytes
Dell(config-ext-macl)# remark 25 IPv6
Dell(config-ext-macl)# seq 30 permit any any ev2 eq 86dd count
bytes
Dell(config-ext-macl)# seq 40 permit any any count bytes
Dell(config-ext-macl)# exit
Dell(conf)# do show mac accounting access-list snickers
interface gig 1/17 in
Extended mac access-list snickers on GigabitEthernet 1/17
Access Control Lists (ACL)
279