CLI Guide

NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies
only for routed traffic egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this
command. You can use this command at the interface context (physical/LAG) to
apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related
Commands
• ip access-list standard — configure a standard ACL.
• ip access-list extended — configure an extended ACL.
ip control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of filters.
Syntax
show ip accounting {access-list access-list-name | cam_count}
interface interface [vrf vrf-name]
Parameters
access-list-name Enter the name of the ACL to be displayed.
228
Access Control Lists (ACL)