CLI Guide

interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet, and then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel, and then a number.
• For a VLAN interface, enter the keyword vlan, and then
a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
vrf vrf-name Enter the keyword vrf then the name of the VRF to view IPv6
VRRP groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series.
Usage Information The following describes the show vrrp ipv6 command.
Line starting
with
Description
GigabitEthernet... Displays the interface, VRRP group ID, and network address.
If the interface is not sending VRRP packets, 0.0.0.0 appears
as the network IP address.
VRF VRF instance to which the VRRP group interface belongs.
State: master... Displays the interface’s state:
• Na/If (not available)
1874
Virtual Router Redundancy Protocol (VRRP)