CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and
forces a new MASTER election if the priority value is lower than the priority value in
the BACKUP virtual routers.
virtual-address
Configure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at
least one virtual IP address for the VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1 [... ip-address12] command.
Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface’s primary IP address.
... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual
routers in dotted decimal format. Separate the IP addresses
with a space. The IP addresses must be on the same subnet
as the interface’s primary IP address.
Defaults Not configured.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
1866
Virtual Router Redundancy Protocol (VRRP)