CLI Guide

Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up GigabitEthernet 2/1 priority-cost 10
Up GigabitEthernet 1/17 priority-cost 10
Dell>
Example (VRRP
VRF)
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet, and then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet, and then the slot/port
information.
• For a Loopback interface, enter the keyword loopback,
and then a number from 0 to 16383.
• For Port Channel interface types, enter the keywords
port-channel, and then a number.
• For a VLAN interface, enter the keyword vlan, and then
the VLAN ID. The VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from
the priority value. The range is from 1 to 254. The default is
10.
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
Virtual Router Redundancy Protocol (VRRP)
1865