CLI Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
When you create a VLT domain on a switch, the Dell Networking OS automatically
assigns a unique unit ID (0 or 1) to each peer switch. The unit IDs are used for
internal system operations. To explicitly configure the unit ID of a VLT peer, use the
unit-id command. Configure a different unit ID (0 or 1) on each peer switch.
This command minimizes the time required for the VLT system to determine the
unit ID assigned to each peer switch when one peer reboots.
vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-Domain Configuration mode.
Syntax
vlt domain domain-id
Parameters
domain-id Enter the domain ID number. Configure the same domain
ID on the peer switch. The range of domain IDs is from 1 to
1000.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
Virtual Link Trunking (VLT)
1849