CLI Guide
Version Description
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
Usage Information When the timer expires, the software checks to see if the VLT peer is available. If
the VLT peer is not available, peer-routing disables on that peer.
If you do not configure this delay value, peer-routing is not disabled even when the
peer is unavailable.
primary-priority
Assign the priority for master election among VLT peers.
Syntax
[no] primary-priority
Parameters
value To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535. The default value is 32768.
Default 32768
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information After you configure a VLT domain on each peer switch and connect (cable) the two
VLT peers on each side of the VLT interconnect, the system elects a primary and
secondary VLT peer device. To configure the primary and secondary roles before
1836
Virtual Link Trunking (VLT)