CLI Guide

multicast peer-routing timeout
To retain synced multicast routes or synced multicast outgoing interface (OIF) after a VLT peer node
failure, configure the timeout value for a VLT node.
Syntax
multicast peer-routing timeout value
To restore the default value, use the no multicast peer-routing timeout
command.
Parameters
value Enter the timeout value (in seconds). The range is from 1 to
1200. The default is 150.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
peer-link port-channel
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan
id}
Parameters
port-channel-
number
Enter the port-channel number that acts as the
interconnect trunk. The range is from 1 to 128.
peer-down-vlan
vlan id
Enter the keywords peer-down-vlan then a VLAN ID to
configure the VLAN that the VLT peer link uses when the
VLT peer is down.
Virtual Link Trunking (VLT)
1833