CLI Guide

link restores between VLT peer switches. The range from 1
to 1200. The default is 90 seconds.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S8420T.
8.3.12.0 Introduced on the S4810.
Usage Information To delay the system from bringing up the VLT port for a brief period to allow IGMP
snooping and Layer 3 routing protocols to converge, use the delay-restore
command. Use this command:
• after a VLT device reloads.
• if the peer VLT device was up at the time the VLTi link failed.
Related
Commands
• show vlt statistics — displays statistics on VLT operations.
delay-restore abort-threshold
Increase the boot up timer to a value greater than 60 seconds.
Syntax
delay-restore abort-threshold <interval>
To remove the boot up timer value, use the no delay-restore abort-
threshold command.
1830
Virtual Link Trunking (VLT)