CLI Guide

routes from another VRF, use the same ASN number that is
specified as the export route target at the source VRF.
route-map-name Enter the name of the route-map to filter the imported
routes.
NOTE: Use the route-map attribute while importing
routes from the global RTM. Route-maps allow you to
filter routes at the import end based on the matching
criteria that you define in the route-map.
Defaults N/A
Command Modes
• VRF mode
• CONFIGURATION mode
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Usage Information
It is possible to configure multiple import conditions per VRF depending on the
exporting VRF.
The export-target and import-target support only the match the protocol and
prefix-list options. Other options that you configure in the route-maps are ignored.
Related
Commands
• ipv6 route-export — exports IPv6 routes to another VRF.
match source-protocol
Specify matching source-protocol criteria while exporting or importing routes.
Syntax
match source-protocol {bgp | isis | ospf | connected | static}
Parameters
bgp Enter the keyword bgp to leak or share routes
corresponding to the BGP protocol.
Virtual Routing and Forwarding (VRF)
1813