CLI Guide

• vlan-stack trunk — specifies a Layer 2 port or port channel as a trunk port to the
Stackable VLAN network.
vlan-stack trunk
Specify a Layer 2 port or port channel as a trunk port to the stackable VLAN network.
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, use the no vlan-
stack trunk command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series. C-Series and S-Series accept
both bytes of the 2-byte S-Tag TPID.
7.8.1.0 Functionality augmented for C-Series and S-Series to
enable multi-purpose use of the port.
7.7.1.0 Functionality augmented for E-Series to enable multi-
purpose use of the port.
7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage Information
Prior to using this command, to place the interface in Layer 2 mode, use the
switchport command.
VLAN Stacking
1803