CLI Guide

Uplink State Group: 6 Status: Enabled, Up
Uplink State Group: 7 Status: Enabled, Up
Uplink State Group: 16 Status: Disabled, Up
Dell# show uplink-state-group 16
Uplink State Group: 16 Status: Disabled, Up
Dell#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface
disabled
Uplink State Group : 1 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 3 Status: Enabled, Up
Upstream Interfaces : Gi 1/25(Up) Gi 1/28(Up)
Downstream Interfaces : Te 5/1(Up) Te 5/1(Up) Te 5/3(Up) Te
5/5(Up) Te 5/6(Up)
Uplink State Group : 5 Status: Enabled, Down
Upstream Interfaces : Gi 1/1(Dwn) Gi 1/3(Dwn) Gi 1/5(Dwn)
Downstream Interfaces : Te 5/2(Dis) Te 5/4(Dis) Te 5/11(Dis)
Te 5/12(Dis) Te 5/13(Dis) Te 5/14(Dis) Te 5/15(Dis)
Uplink State Group : 6 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Gi 1/25(Dwn) Po 8(Dwn)
Downstream Interfaces : Gi 1/30(Dwn)
Related
Commands
• show running-config uplink-state-group — displays the current configuration
of one or more uplink-state groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch or router.
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters
group-id Enter the ID number of an uplink-state group. The range is
from 1 to 16.
1790
Uplink Failure Detection (UFD)