CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only
one of each. Each time this command is issued, it replaces the previously
configured address of the same family, IPv4 or IPv6. The no virtual-ip
command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified
address, then both IPv4 and IPv6 virtual addresses are removed.
Related
Commands
• ip address — assigns a primary and secondary IP address to the interface.
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write {memory compressed| terminal}
Parameters
memory Enter the keyword memory to copy the current running
configuration to the startup configuration file. This
command is similar to the copy running-config
startup-config
command.
compressed Enter the keyword compressed to write the operating
configuration to the startup-config file in the compressed
mode.
Control and Monitoring
179