CLI Guide

• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keyword lag
then a number. The range is from 1 to 128.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to
4294967295.
System Time and Date
1763