CLI Guide

debug ntp
Display network time protocol (NTP) transactions and protocol messages for troubleshooting.
Syntax
debug ntp {adjust | all | authentication | events | loopfilter
| packets | select | sync}
To disable debugging of NTP transactions, use the no debug ntp {adjust |
all | authentication | events | loopfilter | packets | select |
sync} command.
Parameters
adjust Enter the keyword adjust to display information on NTP
clock adjustments.
all Enter the keyword all to display information on all NTP
transactions.
authentication Enter the keyword authentication to display information
on NTP authentication transactions.
events Enter the keyword events to display information on NTP
events.
loopfilter Enter the keyword loopfilter to display information on
NTP local clock frequency.
packets Enter the keyword packets to display information on NTP
packets.
select Enter the keyword select to display information on the
NTP clock selection.
sync Enter the keyword sync to display information on the NTP
clock synchronization.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
System Time and Date
1755