CLI Guide

Version Description
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information When you enable debug spanning-tree bpdu for multiple interfaces, the
software only sends information on BPDUs for the last interface specified.
Related
Commands
• protocol spanning-tree — enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description Enter a description to identify the spanning tree (80
characters maximum).
Defaults none
Command Modes SPANNING TREE (The prompt is “config-stp”.)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced
Spanning Tree Protocol (STP)
1737