CLI Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
• logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
Syntax
logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed
asynchronously.
Simple Network Management Protocol (SNMP) and Syslog
1697