CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information Sample-rate is the average number of packets skipped before the sample is taken.
This command changes the global default sampling rate. You can configure an
interface to use a different sampling rate than the global sampling rate. If the value
entered is not a correct power of 2, the command generates an error message
with the previous and next power of 2 value. Select one of these two packet
numbers and re-enter the command.
Related
Commands
• sflow sample-rate (Interface) — changes the interface sampling rate.
sflow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series,
the range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, 16384, etc. The
default is 32768 packets.
Defaults The Global default sampling.
Command Modes CONFIGURATION
1650
sFlow