CLI Guide

show inventory
Display the switch type, components (including media), and Dell Networking Operating System (OS),
including hardware identification numbers and configured protocols.
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of the stack
member for which you want to display pluggable media inventory.
NOTE: This parameter is available but not supported in Dell
Networking Operating System version 8.3.11.4. Because stacking is not
supported, if you use this parameter, the output displays “Media not
present or accessible” (refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced this version of the command for S-Series. S-Series output
differs from E-Series.
Usage Information If there are no fiber ports in the unit, just the header under show inventory media displays. If
there are fiber ports but no optics inserted, the output displays Media not present or accessible.
Example (S3100)
Dell#show inventory
System Type : S3124P
System Mode : 1.0
Software Version : 9-8(2-126)
Unit Type Serial Part Rev Piece Part ID Rev Svc Tag Exprs Svc Code
Control and Monitoring
149