CLI Guide

• For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a VLAN, enter the keyword vlan then a number

from 1 to 4094.

connected (OPTIONAL) Enter the keyword connected to filter only

directly connected routes.

isis (OPTIONAL) Enter the keyword isis to filter only IS-IS

routes.

ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF

routes.

static (OPTIONAL) Enter the keyword static to filter manually

configured routes.

Defaults Not configured.

Command Modes ROUTER RIP

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

Commands

• ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.

1472

Routing Information Protocol (RIP)