CLI Guide

dscp-list Enter a list of IP DSCP values. The dscp-list parameter
specifies the full list of IP DSCP value(s) for the specified
color. Each DSCP value in a list is separate values by
commas – no spaces (1,2,3) or indicates a list of values
separated by a hyphen (1-3). Range is 0 to 63.
Defaults None
Command Modes CONFIG-COLOR-MAP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information If the specified color-map does not exist, the Diffserv Manager (DSM) creates a
color map and sets all the DSCP values to green (low drop precedence).
The default setting for each DSCP value (0-63) is green (low drop
precedence). This command allows setting the number of specific DSCP values to
yellow or red.
Important Points to Remember
• All DSCP values that are not specified as yellow or red are colored green.
• A DSCP value cannot be in both the yellow and red lists. Setting the red or
yellow list with any DSCP value that is already in the other list results in an error
and no update to that list is made.
• Each color map can only have one list of DSCP values for each color; any DSCP
values previously listed for that color that are not in the new DSCP list are
colored green.
Example
Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16
Related
Commands
• qos dscp-color-map — configures the DSCP color map.
• qos dscp-color-policy— configures a DSCP color policy.
1458
Quality of Service (QoS)