CLI Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series.
Usage Information Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related
Commands
• threshold — specifies the minimum and maximum threshold values of the
WRED profile.
DSCP Color Map Commands
The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic
marked as yellow delivers traffic to the egress queue which will either transmit the packet if it has
available bandwidth or drop the packet due to no ability to send. Traffic marked as red (high drop
precedence) is dropped.
dscp
Sets the number of specific DSCP values for a color map profile to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map profile, use the no dscp {yellow | red}
[dscp-list] command.
Parameters
Yellow Enter the yellow keyword. Traffic marked as yellow delivers
traffic to the egress queue which either transmits the packet
if it has available bandwidth or drops the packet due to no
ability to send.
Red Enter the red keyword. Traffic marked as red is dropped.
Quality of Service (QoS)
1457