CLI Guide

Usage Information To configure the minimum and maximum threshold values for user-defined
profiles, use this command. Additionally, to modify the minimum and maximum
threshold values for the pre-defined WRED profiles, use this command. If you
delete the threshold values of the pre-defined WRED profiles, the profiles revert to
their original default values.
Table 2. Threshold Values for the Pre-defined WRED Profiles
Pre-Defined WRED
Profile Name
Minimum
Threshold
Maximum
Threshold
wred_drop 0 0
100
wred_ten_y 467 4671 100
wred_ten_g 467 4671 50
wred_fortyg_y 467 4671 50
wred_fortyg_g 467 4671 25
Related
Commands
• wred-profile — creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP
markings.
dot1p Enter the keyword dot1p to specify trust dot1p
configuration.
fallback Enter the keyword fallback to classify packets according
to their DSCP or dot1p value as a secondary option in case
no match occurs against the configured class maps.
Defaults none
Command Modes CONFIGURATION (conf-policy-map-in)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
1452
Quality of Service (QoS)