CLI Guide

Defaults For each dot1p Priority, the default CoS queue value is:
• Dot1p Priority : 0 1 2 3 4 5 6 7
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
• show qos dot1p-queue-mapping — displays the dot1p priority to queue
mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
Quality of Service (QoS)
1409