CLI Guide

45
Quality of Service (QoS)
The Dell Networking OS commands for quality of service (QoS) include traffic conditioning and
congestion control. QoS commands are not universally supported on all Dell Networking products.
platform.
Global Configuration Commands
There is only one global configuration QoS command.
qos-rate-adjust
By default, while rate limiting, policing, and shaping, Dell Networking OS does not include the Preamble,
SFD, or the IFG fields. These fields are overhead; only the fields from MAC destination address to the CRC
are used for forwarding and are included in these rate metering calculations. You can optionally include
overhead fields in rate metering calculations by enabling QoS Rate Adjustment.
Syntax
qos-rate-adjustment overhead-bytes
Parameters
overhead-bytes Include a specified number of bytes of packet overhead to
include in rate limiting, policing, and shaping calculations.
The range is from 1 to 31.
Defaults QoS rate adjustment is disabled by default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
1404
Quality of Service (QoS)