CLI Guide

Field Description
• received a (*,G) Join message
Example
Dell# do show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P -
Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J -
Join SPT,
M - MSDP created entry, A - Candidate for MSDP
Advertisement
K - Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 225.1.1.1), uptime 00:40:16, expires 00:00:00, RP
20.40.4.4, flags: SCJ
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(20.10.4.9, 225.1.1.1), uptime 00:06:21, expires 00:02:06,
flags: CT
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(*, 225.1.1.2), uptime 00:40:15, expires 00:00:00, RP
20.40.4.4, flags: SCJ
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(20.10.4.9, 225.1.1.2), uptime 00:06:21, expires 00:02:06,
flags: CT
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
Dell#
show running-config pim
Display the current configuration of PIM-SM snooping.
Syntax
show running-config pim
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
1356
PIM-Sparse Mode (PIM-SM)