CLI Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip pim snooping neighbor commands
shown in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through
PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the
PIM-SM-enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
Dell# show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 1/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 1/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 2/20 ] 00:00:51/00:01:24 v2 0
PIM-Sparse Mode (PIM-SM)
1349