CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip pim snooping interface commands
shown in the following example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping
enabled.
Ver/Mode Displays the PIM version number for each VLAN interface
with PIM-SM snooping enabled:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM
snooping on the interface.
DR Prio Displays the Designated Router priority value configured on
the interface (ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that
interface.
Example (#2)
Dell# show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
Dell#
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about
PIM neighbors that PIM-SM snooping discovered on a
specified VLAN. The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
1348
PIM-Sparse Mode (PIM-SM)