CLI Guide

Parameters
value (OPTIONAL) Enter the traffic value in kilobits per second.
The default is 10 packets per second . A value of zero (0)
causes a switchover on the first packet.
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to configure the PIM router on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
infinity (OPTIONAL) Enter the keyword infinity to never switch
to the source-tree.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
Usage Information This command is applicable to last hop routers on the shared tree towards the
rendezvous point (RP).
no ip pim snooping dr-flood
Disable the flooding of multicast packets to the PIM designated router.
Syntax
no ip pim snooping dr-flood
To re-enable the flooding of multicast packets to the PIM designated router, use
the ip pim snooping dr-flood command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
PIM-Sparse Mode (PIM-SM)
1341