CLI Guide

sweep-max-size Enter the maximum size of datagram in sweep range. The
range is from 53 to 15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is
from 1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast
packets. Enter the IP address in A.B.C.D format.
• For a 1-GigabitEthernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
ethernet Enter the keyword ethernet to test layer2 connectivity.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
test connectivity to the VRF.
Defaults None.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0)P5 Introduced on the S4048–ON.
9.8(0.0)P2 Introduced on the S3048–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
Added support for the outgoing-interface option for
link-local IPv6 addressing on the S4820T.
8.3.12.0 Added support for the outgoing-interface option for
link-local IPv6 addressing on the S4810.
134
Control and Monitoring