CLI Guide

PIM-Sparse Mode (PIM-SM)

The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating

software on the platform.

The following describes the IPv4 PIM-SIM commands.

IPv4 PIM-Sparse Mode Commands

The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.

clear ip pim rp-mapping

The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP)

advertisement.

Syntax

clear ip pim [vrf vrf-name] rp-mapping [rp-address]

Parameters

vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name

of the VRF to configure this setting on that VRF.

NOTE: Applies to specific VRF if input is provided, else

applies to Default VRF.

rp-address (OPTIONAL) Enter the RP address in dotted decimal format

(A.B.C.D).

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.1) Introduced on the Z9500.

1324

PIM-Sparse Mode (PIM-SM)