CLI Guide
Parameters
number Specify the number of paths. The range is from 1 to 64. The
default is 8 paths.
Defaults 8
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
passive-interface
Disable (suppress) sending routing updates on an interface.
Syntax
passive—interface interface
To enable sending routing updates on an interface, use the no passive-
interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Open Shortest Path First (OSPFv2 and OSPFv3)
1297