CLI Guide

Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
OSPFv3 Commands
Open shortest path first version 3 (OSPFv3) for IPv6 is supported on the platform.
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on)
remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most
changes were necessary to handle the increased address size of IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-
encryption-type] key
Parameters
area area-id
Area for which OSPFv3 traffic is to be authenticated. For
area-id, you can enter a number.
The range is from 0 to 4294967295.
ipsec spi number
Security Policy index (SPI) value that identifies an IPsec
security policy.
1276
Open Shortest Path First (OSPFv2 and OSPFv3)