CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to
an alternate path quickly but requires more CPU usage.
Example
Dell# conf
Dell(conf)# router ospf 1
Dell(conf-router_ospf-1)# timer spf 2 5
Dell(conf-router_ospf-1)# show config
!
router ospf 1
timers spf 2 5
Dell(conf-router_ospf-1)# end
timers throttle lsa all
Configure LSA transmit intervals.
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval Set the minimum interval between initial sending and
resending the same LSA. The range is from 0 to 600,000
milliseconds.
hold-interval Set the next interval to send the same LSA. This interval is
the time between sending the same LSA after the start-
interval has been attempted. The range is from 1 to 600,000
milliseconds.
max-interval Set the maximum amount of time the system waits before
sending the LSA. The range is from 1 to 600,000
milliseconds.
1274
Open Shortest Path First (OSPFv2 and OSPFv3)