CLI Guide

show ip ospf statistics
Display OSPF statistics.
Syntax
show ip ospf [process-id | vrf vrf-name] statistics global |
[interface name {neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
display statistics corresponding to the OSPF process that is
tied to a specific VRF.
global Enter the keyword global to display the packet counts
received on all running OSPF interfaces and packet counts
OSPF neighbors receive and transmit.
interface name (OPTIONAL) Enter the keyword interface then one of the
following interface keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
neighbor router-
id
(OPTIONAL) Enter the keyword neighbor then the
neighbor’s router-id in dotted decimal format (A.B.C.D.).
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
1266
Open Shortest Path First (OSPFv2 and OSPFv3)