CLI Guide

Version Description
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information Set the time interval to a number large enough to prevent unnecessary
retransmissions.
ip ospf transmit-delay
To send a link state update packet on the interface, set the estimated time elapsed.
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
seconds Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 1
second.
This value must be greater than the transmission and
propagation delays for the interface.
Defaults 1 second
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
1224
Open Shortest Path First (OSPFv2 and OSPFv3)