CLI Guide

Parameters
vrf-name Enter the vrf-name to specify the VRF that is used by the
TELNET server.
any Enter the keyword any to enable server from any VRF.
management Enter the keyword management to specify a management
VRF that is used by the TELNET server.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information You can enable the TELNET server on either a management VRF or a user-defined
VRF but not both. If you do not specify a VRF name, then the TELNET server is
enabled on the default VRF.
Example
Dell(conf)# ip telnet server vrf vrf1
Dell(conf)# no ip telnet server vrf
Dell(conf)# ip telnet server vrf management
Dell(conf)# no ip telnet server vrf
Dell(conf)#
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[interface] command.
Parameters
interface Enter the following keywords and the interface information:
122
Control and Monitoring