CLI Guide

Object Tracking

Object Tracking supports IPv4 and IPv6, and is available on the Dell Networking platforms.

Object tracking allows you to define objects of interest, monitor their state, and report to a client when a

change in an object’s state occurs. The following tracked objects are supported:

• Link status of Layer 2 interfaces

• Routing status of Layer 3 interfaces (IPv4 and IPv6)

• Reachability of IPv4 and IPv6 routes

• Metric thresholds of IPv4 and IPv6 routes

You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a

notification when the state of a tracked object changes.

IPv4 Object Tracking Commands

The following section describes the IPv4 VRRP commands.

debug track

Enables debugging for tracked objects.

Syntax

debug track [all | notifications | object-id]

Parameters

all Enables debugging on the state and notifications of all

tracked objects.

notifications Enables debugging on the notifications of all tracked

objects.

object-id Enables debugging on the state and notifications of the

specified tracked object. The range is 1 to 500.

Defaults Enable debugging on the state and notifications of all tracked objects (debug

track all).

Command Modes

• EXEC

• EXEC Privilege

1168

Object Tracking