CLI Guide

• other-config-flag — enable the verification of the advertised other
configuration parameter.
• reachable-time — set the advertised reachability time.
• retrans-timer — set the advertised retransmission time.
• router-preference maximum — enable the verification of the advertised default
router preference (DRP) value.
• trusted-port — apply the policy to trusted ports.
• ipv6 nd raguard attach-policy — apply the IPv6 RA guard to a specific interface.
trusted-port
Allow bypassing the configured RA guard validation and forwards the RA packets received on the
interface, which has the trusted port policy attached.
Syntax
trusted-port
To reset the policy applied to the trusted port, use the no trusted-port
command.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9000 switches.
Usage Information Use this command to disable all the RA guard policies.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd raguard policy policy-name — define the router advertisement (RA)
guard policy name and enter the RA guard policy configuration mode.
Neighbor Discovery Protocol (NDP)
1167