CLI Guide

retrans-time
Enable the verification of the configured retransmission timer value in the received RA packets.
Syntax
retrans—timer value
To reset the advertised retransmission interval, use the no retrans-timervalue
command.
Parameters
value Enter the advertised retransmission time interval in
milliseconds. The range is from 100 to 4,294,967,295
milliseconds.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9000 switches.
Related
Commands
ipv6 nd raguard policy policy-name — define the router advertisement (RA) guard
policy name and enter the RA guard policy configuration mode.
ipv6 nd ra-guard enable — configure the RA guard related commands.
router-lifetime
Set the router lifetime.
Syntax
router—lifetime value
Parameters
value Enter the router lifetime in seconds. The range is from 0 to
9,000 seconds.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Neighbor Discovery Protocol (NDP)
1163