CLI Guide

To reset the MTU value, use the no mtu value command.
Parameters
value Enter the maximum transmission unit value in bytes. The
range is from 1,280 to 11,982 bytes.
Defaults 0
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd raguard policy policy-name — define the RA guard policy name and
enter the RA guard policy configuration mode.
other-config-flag
Enable the verification of the advertised other configuration parameter. If this command is not
configured, the verification process is bypassed.
Syntax
other-config-flag {on | off}
To reset the other configuration parameter, use the no other-config-flag
{on | off} command.
Parameters
on Enter the keyword on to set the other-config-flag value as
ON.
off Enter the keyword off to set the other-config flag value as
OFF.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Neighbor Discovery Protocol (NDP)
1161