CLI Guide

ip http vrf
Configure an HTTP client with a VRF used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Parameters
management Enter the keyword management for configuring the
management VRF that uses an HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not
specify a VRF name, the HTTP client uses the default VRF.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Usage Information To make the HTTP clients VRF-aware, use the ip http vrf command. The HTTP
client uses the VRF name that you specify to reach the HTTP server. If you do not
specify a VRF name, the HTTP client uses the default VRF.
ip ftp password
Specify a password for outgoing FTP connections.
Syntax
ip ftp password [encryption-type] password
To remove a password and return to the default setting, use the no ip ftp
password [password] command.
Parameters
encryption-type (OPTIONAL) Enter one of the following numbers:
116
Control and Monitoring