CLI Guide
35
Multicast
The multicast commands are supported by Dell Networking OS on all S3100 series platform.
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the clear ip pim tib command.
Syntax
clear ip mroute [vrf vrf-name] {group-address [source-address]
| * | snooping}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group-address
[source-address]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping
route table entries.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
Multicast
1141