CLI Guide

show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer address Enter the keyword peer then the peer address in a dotted
decimal format (A.B.C.D.).
sa-cache Enter the keywords sa-cache to display the Source-Active
cache.
summary Enter the keyword summary to display an MSDP peer
summary.
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
Example
Dell# show ip msdp peer 100.1.1.1
Peer Addr: 100.1.1.1
Local Addr: 100.1.1.2(639) Connect Source: none
State: Established Up/Down Time: 00:00:08
Timers: KeepAlive 60 sec, Hold time 75 sec
SourceActive packet count (in/out): 0/0
SAs learned from this peer: 0
SA Filtering:
Input (S,G) filter: none
1120
Multicast Source Discovery Protocol (MSDP)