CLI Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the E-Series.
Usage Information Dell Networking OS counts the SA messages originated by itself and those
messages received from the MSDP peers. When the total SA messages reach this
limit, the subsequent SA messages are dropped (even if they pass RPF checking and
policy checking).
If the total number of SA messages is already larger than the limit when this
command is applied, those SA messages that are already in Dell Networking OS
continue to be accepted. To enforce the limit in such situation, use the clear ip
msdp sa-cache command.
Related
Commands
• ip msdp peer — configure the MSDP peer.
• clear ip msdp peer — clear the MSDP peer.
• show ip msdp — display the MSDP information.
ip msdp shutdown
Administratively shut down a configured MSDP peer.
Syntax
ip msdp shutdown {peer address}
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1118
Multicast Source Discovery Protocol (MSDP)