CLI Guide

Version Description
7.5.1.0 Added option for SA upper limit and the description
option.
6.2.1.1 Introduced
Usage Information
The connect-source option is used to supply a source IP address for the TCP
connection. When an interface is specified using the connect-source option, the
primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the
limit when this command is applied, those SA messages continue to be accepted.
To enforce the limit in such situation, use the clear ip msdp peer command to
reset the peer.
Related
Commands
• ip msdp sa-limit — configure the MSDP SA Limit.
• clear ip msdp peer — clear the MSDP peer.
• show ip msdp — display the MSDP information.
ip msdp redistribute
Filter local PIM SA entries in the SA cache. SAs which the ACL denies time out and are not refreshed. Until
they time out, they continue to reside in the MSDP SA cache.
Syntax
ip msdp redistribute [list acl-name]
Parameters
list acl-name Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Multicast Source Discovery Protocol (MSDP)
1115